Euro-pro 372 EN User Manual download pdf (Page 17)

HE MMING

(Model 377 only)

P res ser foot

P attern selector

S titch length dial

hemmer foot

M( )

1 to 4

R aise the foot and the needle to its highest position. R eplace the

foot with the hemmer foot.

F old over the fabric edge by about 3mm (1/8 inches ) and place it

under the foot. S ecure the folded edge with a few stitches. Take

out the workpiece and draw the hem into the hemmer foot by

pulling on the threads.

Lower the foot and swe the hem.

During s ewing, fold the fabric to the left a little and allow it to

run into the hemmer foot.

Make s ure that the fabric does not move under the right half of

the foot. The fabric must be fed into the s croll of the hemmer

sufficiently so that the workpiece edge runs freely through the

groove under the foot.

hemmer foot

3mm

S E WING B L IND HE MS

(Model 377/374/373/372/372H)

Model 377

Model 373/372/372H

Model 374

blind hem foot

Pattern selector

Presser foot

Stitch length dial

1 to 3

B ( )

E ( )

blind hem foot

1 to 3

1. T urn up the hem to the desired width and press. ( F ig. 1)

2. Fold hem back against the right side of the garment with

top edge of hem extending about 4 mm (1/6 inches) to the

right side of the garment folded. (F ig. 2)

3. P lace the garment under the foot so that double-folded edge

runs along the hemlguide and lower the foot.

S ew slowly for better control, making sure the narrow

zigzag stitches are s ewn on the hem edge and wide zigzag

stitches will just catch one thread of folded edge. (F ig. 3)

4. Unfold the fabric and you will have a bling stitch hem

(Fig. 4)

(F ig. 1)

4mm (1/6 )

(F ig. 2)

(F ig. 1)

G uide

a djus ting

sc re w

G uide

(F ig. 3)

(F ig. 4)

F oided edge

1 2 ... 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments

Euro-pro 372 EN User Manual Page 17

Comments to this Manuals

Related products and manuals for Sewing machines Euro-pro 372 EN