Euro-Pro 374 Instruction Manual download pdf (Page 11)

THREADING THE BOBBIN CASE

Hold the bobbin between the thumb and forefinger of your right

hand and pull off about 15cm (6 inches) of thread.

2. Pull the thread into the slot in the edge of the bobbin case.

1. Hold the bobbin case in your left hand as shown and place

the filled bobbin inside.

3. Now pull the thread under the tension spring and into the

thread eyelet.

To insert the bobbin case and bobbin......

Ensure that about 15 cm (6 inches) of thread extends

out of bobbin. Hold the bobbin case so that long

finger on case points up. Open the latch of bobbin

case. Slip the bobbin case over the center pin of

hook and press in place until the long finger of the

bobbin case enters the notch entirely to lock the

bobbin in place. Release latch and press it down.

WINDING THE BOBBIN

1. Draw thread from spool through

bobbin winder tension disc as shown.

2. Pull end of thread through hole in bobbin

as shown.

3. Push bobbin winder shaft to far left position,

if it is not already there. Place bobbin onto

shaft with end of thread coming from top of

bobbin. Push bobbin winder shaft to right

until it clicks. Hold onto end of thread.

4. Start machine. The thread that is held will

snap or may be trimmed with a scissors,

Bobbin will cease turning when completely

filled. Push shaft to left to remove bobbin.

English

bobbin case

bobbin

slot

tension spring

eyelet

latch

long finger

notch

latch

When the bobbin winding is incorrect, release

the screw of the upper thread guide and adjust

the thread guide up or down until the winding

of the bobbin is balanced.

1 ... 10 11 12 ... 23

Comments to this Manuals

No comments

Euro-Pro 374 Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Sewing machines Euro-Pro 374